Narrow down by specifying conditions
There are currently 4292 hits.
Mentor: ModelSim® limits the number of files to 30 when outputting files with $fopen in simulation. Please suggest me a workaround.
Category: Simulation
Tools: ModelSim®
device:-
<Message>
Warning: (vsim-3533) [FOFIW] - No mcd channels available. Failed to open file "./<filename> for writing.
Due to Verilog/language limitations, there is no workaround in the tool.
As mentioned in the Knowledge below, if you don't want to use the mcf function, try using file descriptor with type specified.
https://support.sw.siemens.com/en-US/product/852852093/knowledge-base/MG60108
Experienced FAE
Free consultation is available.
From specific product specifications to parts selection, the Company FAE will answer your technical concerns free of charge. Please feel free to contact us.