Narrow down by specifying conditions
There are currently 4292 hits.
I tried to use the set_case_analysis command in SDC, but it is ignored by TimeQuest. Is this command available? Is there a workaround if it is not possible?
The TimeQuest Timing Analyzer does not support set_case_analysis. Also, the replacement command for set_case_analysis to assign a fixed value is not TimeQuest Timing Analyzer.
If you want to use this command, you need to parse it using PrimeTime.
For details, please refer to the URL link below.
https://www.altera.com/support/support-resources/knowledge-base/solutions/rd07162010_503.html
The same link also contains information about the SDC commands supported by the TimeQuest Timing Analyzer.
Experienced FAE
Free consultation is available.
From specific product specifications to parts selection, the Company FAE will answer your technical concerns free of charge. Please feel free to contact us.