Narrow down by specifying conditions
現在1889件がヒットしています。check
Facility owned by Macnica [Analysis and Evaluation Room]
At Macnica, we respond to technical requests from a wide range of fields, mainly from aerospace customers.
We have established an ``Analysis and Evaluation Room'' in our own building facility (Shin-Yokohama Macnica 2nd Building 1F). We provide better services based on the experience and technology we have cultivated over the years.
What you can do in the analysis evaluation room
Radiographic examination (X-ray examination)
As part of screening and fracture physical analysis (DPA),
We perform radiographic inspections (X-ray inspections) based on MIL standards.
・ MIL-STD-883 Test Method 2012
・ MIL-STD-750 Test Method 2076
・ MIL-STD-981 Appendix B
In addition, radiographic inspection (X-ray inspection) complies with “ASTM E801”
Adopted “IQI” (Image Quality Indicators).
Provides X-ray images with high image quality It is possible to.
In the X-ray inspection equipment installed in the analysis evaluation room,
“X-ray fluoroscopic observation” in fine focus mode and
"Analysis of internal structure" by X-ray CT observation is possible.
Take advantage of these features to Electronic parts and boards (including component mounting boards)
For a wide range of needs such as non-destructive inspection when defects occur We will also answer.
Visual inspection
In the same way as radiographic inspection (X-ray inspection), we perform "visual inspection" based on MIL standards.
・ MIL-STD-883 Test Method 2009
・ MIL-STD-750 Test Method 2071
It is also possible to "provide high-quality images" using the attached camera and digital microscope (installed in a separate room).
Initial failure analysis
As a non-destructive "initial failure analysis" when a problem occurs,
Mechanical inspection such as radiographic inspection (X-ray inspection) and appearance inspection,
It is possible to carry out electrical inspection such as simple characteristic measurement using a curve tracer.
Source inspection/examination
In the analysis and evaluation room, it is possible for customers to conduct source inspections/examinations.
At that time, we will support you so that your work can proceed smoothly.
In addition, support for source inspection / examination implementation at the request of customers,
Substitution is also possible. (It is also possible to support and act on behalf of other than the analysis evaluation room.)
If you have any problems about "Aerospace parts", please contact us first!
At times like this! !
・ I would like to perform a “radiographic examination” as a screening.
・I want to carry out “Parts DPA”.
- “Radiographic examination” is not performed by the manufacturer. I would like to implement this additionally.
・Many parts delivered recently have poor appearance. I would like them to conduct a “visual inspection before delivery.”
- A problem occurred with a component/board. First, we would like to perform “initial failure analysis” non-destructively.
・We would like to conduct a “source inspection/examination” but we do not have enough manpower, so we would like some help.
Such.
We will provide support based on Macnica 's "rich experience" and "high technology."