- Semiconductor BusinessHOME
- Products and Services of Macnica,Inc.
-
technical information
-
Events and Seminars
- Handling Manufacturer
- Support
- Inquiry
- Click here to purchase products
- Semiconductor business e-mail magazine registration
Narrow down by specifying conditions
There are currently 4342 results.
Siemens EDA: Can I run HyperLynx SI at different voltages than what is set in the IC's IBIS model?
You can change the Vcc setting in HyperLynx SI by doing the following:
- Open Setup > Options > General
- Change IC-model voltage references to second from top "When assigning a model to an IC pin, use a power -supply net connected to the IC"
- Vcc pin pull-down in Assign Models window is enabled to change Vcc voltage
- Additional voltage levels can be added via Setup > Power Supply
Experienced FAE
Free consultation is available.
From specific product specifications to parts selection, the Company FAE will answer your technical concerns free of charge. Please feel free to contact us.