The output of the PLL is connected directly to the I/O pin. Since it is a clock output, the set_output_delay constraint cannot be applied. I would like to know the delay value of the clock output in TimeQuest. How can I check it?

Narrow down by specifying conditions

There are currently 4292 hits.

I am connecting the output of the PLL directly to an I/O pin. I cannot constrain set_output_delay because it is a clock output. I would like to know the delay value of the clock output in TimeQuest, how can I check it?

Quartus Prime Timing Constraints/Analysis Clock/PLL

Software: Quartus®II (TimeQuest)
Category: Timing Constraint/Analysis

If you want to report the delay time of a specific path, you can check it with TimeQuest's Tasks window ⇒ Custom Reports ⇒ Report Path.

1) Double-click Report Path…
2) Click the … button to the right of the To column to launch Name Finder.
3) Set the upper left Collection to get_ports and put the pin name (* can be used) in Filter.
4) Click the List button.
5) Select the required I/O from the left column, move it to the right column with the > button, and click the OK button.
6) In Number of Report Paths, you can specify how many of the paths to the pins specified in Worst order.
7) Changing the Report panel name will change the name of the report so you can compare it with other Path Reports.
8) Check the Delay value.

Experienced FAE
Free consultation is available.

From specific product specifications to parts selection, the Company FAE will answer your technical concerns free of charge. Please feel free to contact us.

Inquiry form