I am using a Triple Speed Ethernet (TSE) design configured at full duplex. Although the link with the other device is successfully established, the message is detected as half-duplex. What factors could be considered?

Narrow down by specifying conditions

There are currently 4332 hits.

I am using a triple speed ethernet (TSE) with a design set to full duplex. The link with the opposite device side is established normally, but it is detected as half-duplex in the message. What are the possible factors?

There is a possibility that the opposite device side (or repeater such as HUB) is connected to a port that does not support auto-negotiation, so please check.

Experienced FAE
Free consultation is available.

From specific product specifications to parts selection, the Company FAE will answer your technical concerns free of charge. Please feel free to contact us.

Inquiry form

Site Search