When using Intel: Cyclone® V DDR3 EMIF (External Memory Interface) IP, is it possible to check the values set in the mode registers (MR0-3) when starting user mode by simulation or on the actual device?

Narrow down by specifying conditions

There are currently 4332 hits.

Intel: When using the Cyclone® V DDR3 EMIF (External Memory Interface) IP, is it possible to check the values set in the mode registers (MR0-3) at the start of user mode through a simulation or actual device?

Cyclone Quartus Prime External Memory

Category: External memory interface
Tools: Quartus® Prime
Device: Cyclone® V

Please note that due to IP/Device configuration, this value cannot be checked with Signal Tap during actual machine operation.

In the simulation, it can be confirmed as the address signal value (= setting value) at the time of the MRS command immediately before the end of calibration (-> start of user mode).
Included in the information displayed in the Transcript window in the ModelSim® simulation of the Example Design.
It will be displayed like "MRS Command - MRS [ 0 ] -> 231 ". (The setting 231 looks like a decimal number, but it's a hexadecimal number.)

Enlarge image

Experienced FAE
Free consultation is available.

From specific product specifications to parts selection, the Company FAE will answer your technical concerns free of charge. Please feel free to contact us.

Inquiry form

Site Search