Intel: If you use a combination of Nios® II and Altera Serial Flash Controller and the Nios II software is also loaded from EPCS/EPCQ flash memory, you can use the QSPI Flash offset for the Nios® II Reset Vector, but the same applies to the Legacy ECPS Flash Controller. Is it possible to set it?

Narrow down by specifying conditions

There are currently 4292 hits.

Intel: When Nios® II and Altera Serial Flash Controller are combined and the Nios II software is also loaded from EPCS/EPCQ flash memory, the Nios® II Reset Vector can use the QSPI Flash offset, but the Legacy ECPS Flash Controller does the same. is it possible to set

Nios II

Category: Nios® II
Tools: Quartus® Prime (Platform Designer)
device:-

No, it's not possible.
When using the Legacy ECPS Flash Controller, the Nios II Reset Vector must specify address 0x0 of the Legacy EPCS Flash Controller.

For more information, please see the document below.

Generic Nios II Booting Methods User Guide
https://www.altera.com/en_US/pdfs/literature/ug/niosii_generic_booting_methods.pdf

Experienced FAE
Free consultation is available.

From specific product specifications to parts selection, the Company FAE will answer your technical concerns free of charge. Please feel free to contact us.

Inquiry form