Intel: When setting the nIO_PULLUP pin of Cyclone® 10 GX to High level, is it correct to connect it to VCC via a 1kΩ pull-up resistor?

Narrow down by specifying conditions

There are currently 4342 results.

Intel: If you drive the Cyclone® 10 GX nIO_PULLUP pin to a high level, are you sure it's connected to VCC via a 1kΩ pull-up resistor?

Cyclone board

Category: Specifications
tool:-
Device: Cyclone® 10

Make sure it is connected to VCC (0.90V) via a 1kΩ pull-up resistor.

Reference information
https://www.intel.com/content/www/us/en/docs/programmable/683417/current/dedicated-configuration-jtag-pins.html
(Search for nIO_PULLUP.)

Experienced FAE
Free consultation is available.

From specific product specifications to parts selection, the Company FAE will answer your technical concerns free of charge. Please feel free to contact us.

Inquiry form

Site Search