Narrow down by specifying conditions
There are currently 4292 hits.
In the Arria® 10 Transceiver Native PHY parameters, enabling Dynamic Reconfiguration in Dynamic Reconfiguration adds ports called reconfig_***. Do I need to do anything about them?
Category: Transceiver
Tools: Quartus® Prime
Device: Arria® 10
These ports should be connected as follows:
If you only need access from the Transceiver Toolkit, connect 100 to 125 MHz to reconfig_clk, connect a High-Active reset signal to reconfig_reset, fix other input signals to 0, and leave the output signal open.
Experienced FAE
Free consultation is available.
From specific product specifications to parts selection, the Company FAE will answer your technical concerns free of charge. Please feel free to contact us.