Please tell me how to calculate the slew rate value (DQ, Add/CMD, DQS, CK) to enter in the Setup and Hold Derating section of the Board Settings section of the SDRAM Controller with UniPHY. Also, is it necessary to set the Channel Signal Integrity for a single rank?

Narrow down by specifying conditions

現在 4342 件がヒットしています。

Please tell me how to find the slew rate value (DQ, Add/CMD, DQS, CK) to be entered in Setup and Hold Derating in the Board Settings section of SDRAM Controller with UniPHY. Also, do I need to set the Channel Signal Integrity on a single rank?

Category: EMIF
Tools: Quartus® Prime / Quartus® II
device:-

Perform a board simulation for the slew rate, and select the one that makes the slope steeper. (worst case (maximum))

Also, there is no need to set Channel Signa Integrity on a single rank.
Set the parameter when using multiple ranks.

Experienced FAE
Free consultation is available.

From specific product specifications to parts selection, the Company FAE will answer your technical concerns free of charge. Please feel free to contact us.

Inquiry form

Site Search