When using Transceiver Native PHY, how should I configure it using the Transceiver PHY Reset Controller GUI to use the reset function (auto reset) after power-up?

Narrow down by specifying conditions

There are currently 4341 results.

How can I configure the Transceiver PHY Reset Controller GUI to use the reset function (auto reset) after power-up when using the Transceiver Native PHY?

Category: Transceiver
Tools: Quartus® II
Device: Cyclone® V

Check the following items in the settings on the GUI of the Transceiver PHY Reset Controller.

Enable TX PLL reset control
Enable TX channel reset control
Enable RX channel reset control

Experienced FAE
Free consultation is available.

From specific product specifications to parts selection, the Company FAE will answer your technical concerns free of charge. Please feel free to contact us.

Inquiry form

Site Search