When using the Transceiver PHY, some input pins may not be used depending on the operating mode. What should I do?

Narrow down by specifying conditions

There are currently 4342 results.

When using the Transceiver PHY, there are input pins that are not used depending on the operating mode. What should I do?

Category: Transceiver
Tools: Quartus® II
Device: Cyclone® V

Please proceed as follows.

reconfig_to_xcvr[n:0], reconfig_from_xcvr[m:0] : Create a Transceiver Reconfiguration Controller and connect it to the port with the same name
unused_tx_parallel_data[xx:0] : Fixed to Low

Experienced FAE
Free consultation is available.

From specific product specifications to parts selection, the Company FAE will answer your technical concerns free of charge. Please feel free to contact us.

Inquiry form

Site Search