Protect your equipment from static electricity! USB Type-C compatible ESD protection diode "TPD1E01B04"

Narrow down by specifying conditions

現在1888件がヒットしています。check

Product Pickup Interface Texas Instruments

Features of "TPD1E01B04"

Connectors for hot-plug interfaces such as USB are directly accessible to the user.
Therefore, it is a place where equipment failure due to static electricity (ESD) is likely to occur.

By attaching ESD protection diodes to such places, the energy of ESD (static electricity) can be released to the ground and the current flowing through the equipment can be reduced.

Texas Instruments' ESD protection diode TPD1E01B04 has the following features:

1. Supports USB Type-C and Thunderbolt3 high-speed communication

Industry-leading ultra-low parasitic capacitance for ESD devices minimizes signal degradation and enables data rate transfer up to 20Gbps.

2. Low dynamic resistance and clamping voltage protect equipment from static electricity

Low dynamic resistance and clamping voltage divert ESD (electrostatic) energy to ground, maximizing current flow through equipment.
Therefore, you can increase the reliability of your products.

"TPD1E01B04EVM" module ready for evaluation

The TPD1E01B04EVM evaluation module allows evaluation of the TPD1E01B04 ESD protection diode for USB Type-C and Thunderbolt 3.

Article header library 128057 pic01 1 — TPD1E01B04EVM Evaluation Module

This evaluation module contains six TPD1E01B04 devices.

Five TPD1E01B04 (D1-D5) are configured as test points for inputting ESD. The remaining TPD1E01B04 (D6) has two SMA connectors and can be connected to a network analyzer (high frequency measurement equipment).

The TPD1E01B04 (D6) can also be used to acquire clamped waveforms with an oscilloscope during ESD testing.