Major features

The definitive version of ultra-large-capacity configuration ROM

Config speed and delay time can be set by software

Configure the largest FPGA in less than 1 second

No need to worry about ROM capacity with super large capacity

Uses microSD

usability

・Store circuit data in easily available microSD

・Ultra-large capacity (maximum 2GByte = 16Gbit data capacity)

・A microSD of 512MByte or more is included as standard.
Available immediately after purchase! !

・Up to 25MByte/s high-speed update

・Easy circuit update by microSD replacement

・The circuit can be rewritten with a commercially available card reader/writer

(Dedicated writing software is provided free of charge)

・Equipped with configuration status display LED

・Can be stored/referenced in the module

Multi-channel compatible

Fast configuration

・Simultaneous configuration of 1 to 8 FPGAs in parallel

・Up to 160Mbit/s in Parallel mode

・Maximum 40Mbit/s in serial mode

(1-4 channels)

Adjustment function

Ultra-compact/lightweight

・Configurable clock speed can be changed in 4 steps

・Additional adjustment of configuration delay time

・Length 28mm x Width 23mm x Height 8mm

postage stamp size

・Weight 10 grams

lead free

・SDLink conforms to RoHS.

Power-supply voltage

3.3V and FPGA configuration power

* In addition to the 3.3V power supply for microSD, FPGA configuration power supply

(3.3V or 2.5V or 1.8V) must be supplied from the user board side.

Current consumption (Typical value)

85mA in configuration, 55mA in idle

capacity

microSD card capacity (up to 2GB)

*However, 1MByte is used as the system data management area.

Number of FPGA devices

1 to 8 devices

* All FPGAs must be prepared for the same configuration speed, voltage, and mode.

Maximum config speed

Parallel mode: 160Mbit/s

Serial mode: 40Mbit/s (1-4 devices) / 20Mbit/s (5-8 devices)

*When using a high-speed type microSD card.

* In Parallel mode, FPGA device is limited to 1 device.

* The configuration speed can be changed in 4 stages.

Start-up additional delay time

Additional adjustment from +0ms to 2550ms

*Additional delay time from the end of microSD initialization to the start of configuration

writing method

Write via microSD card reader/writer from dedicated software

*Download the dedicated software from here

accessories

1 microSD card (normal speed type) of 512MByte or more

order code

SL-001

FlashLink compatible version

There is also a 3.3V single power supply SL001-FL that shares the same pin assignment as FlashLink.