Narrow down by specifying conditions
現在1887件がヒットしています。check
If you want to learn SoC FPGA, start with this board!
"DE10-Nano Kit" is a Cyclone ® V SoC with a built-in ARM ® processor, an accelerometer, an AD converter, an HDMI terminal,
A compact and inexpensive development kit equipped with various I/Fs.
Compared to the previous product DE0-Nano SoC Kit, the number of LEs has increased by about 2.7 times, and an HDMI_TX interface has been added.
 |
 |
|
board photo |
Block Diagram |
Click image to enlarge
specification
FPGA part
- Cyclone ® V SE 5CSEBA6U23I7 with 110K LE
- Configuration ROM EPCS128
- Onboard USB-Blaster II for programming; JTAG mode
- HDMI TX (compatible with DVI 1.0 and HDCP v1.4)
- 2 push buttons
- 4 slide switches
- 8 green user LEDs
- Three 50MHz clock resources from clock generator
- Two 40-pin expansion headers
- Arduino expansion headers (Uno R3 compatible) to connect with Arduino shields
- One 10-pin analog input expansion header (shared with Arduino analog input)
- A/D converter, 4-pin SPI interface
HPS (Hard Processor System)
- 800MHz dual-core ARM Cortex-A9 processor
- 1GB DDR3 SDRAM (32-bit data bus)
- 1 Gigabit Ethernet PHY with RJ45 connector
- USB OTG port, USB Micro-AB connector
- Micro SD card socket
- Accelerometer (I2C interface + interrupt)
- UART - USB, USB Mini B Connector
- Warm reset and cold reset buttons
- 1 user button and 1 user LED
- LTC 2x7 expansion header
Kit contents
 |
|
Related Documents
Click here for the latest data on this product (Terasic website)
The latest technical materials are provided on the RocketBoard site