Site Search

Hello. It's a plum rice ball.

 

After completing the design in the hands-on workshop, I launched the Quartus ® II Programmer to write to the device.

When programming, select hardware, select mode, select file, and select programming options.

Since this time we will write to the device, check the programming option Program / Configure and press start.

I noticed the plum rice ball here.

Notice that there are 6 fields that can be checked next to Program / Configure.

What are they used for?

 

So this time I will study programming options other than Program / Configure.

 

The file types affected by each option are summarized in the table below.

Programming options other than Program / Configure are for CPLD / Configuration ROM as described in the table below.

That's why the Cyclone ® IV E device was specified this time, so options other than Program / Configure were grayed out in the above figure.

We will now explain each option.

Verify

This option allows you to compare and verify the programming data selected by the Programmer and the programming data written to the device.

The following error message is displayed only when the two data are different.

This function is convenient when you want to check the functions written in the device.

Blank-Check

This option allows you to confirm that the contents of the device are in an initialized state.

The following error message is displayed only when data has already been written.

This function is useful when checking whether writing to the device is possible.

Examine

This option allows you to extract the data written to the device and save it as a programming file.

The extracted file is displayed on Programmer as a pof file.

This function is convenient when you want to write data written to a device to another device.

Erase

This option allows you to erase the data written to the device.

Security Bits

An option to protect data written to the device.

Specifically, it is used to prevent data from being sucked out by Examine and to prevent data from being identified by Verify.

This allows you to protect important design data. (Supported in MAX7000, MAX3000)

ISP CLAMP

This option allows you to set the I/O status during programming using the ISP file. (Supported in MAX7000B, MAX II)

You can enable ISP CLAMP by creating an isp file.

Please check here for details.

Summary

I found that Programmer has various options regarding CPLD / configuration ROM as well as writing function.

If you have a chance, please help us.