- Wider electrode distance compared to standard products
・ AEC-Q200 certified lineup
- Supports high voltage range from 16 V to 3 kV
- Wide range of sizes from 0603 to 2225​
・ FlexiCap ™ resin electrodes can be used

Even if a crack were to occur at the edge of the capacitor, the capacitor is designed with a "safe zone" on both ends, as shown in the figure, so that only the innermost part of the capacitor is the active area. We assume that the crack will occur at the end of the capacitor, but because the internal electrode pattern is pulled back from the opposite edge of the chip, even if a crack is induced, it is much less likely to propagate through the active overlap area and cause an electrical short.

- Two electrodes arranged in series on one device
・ AEC-Q200 certified lineup
- Supports a voltage range of 5.0V to 2.50V​
- Wide range of sizes from 0603 to 1812​
・ FlexiCap ™ resin electrodes can be used

Sometimes called a serial design, this design works by eliminating the short circuit path between electrodes of opposite polarity, since a single capacitor has a structure equivalent to a series connection of two capacitors. Therefore, even if a crack occurs at the end of the capacitor and one capacitor is destroyed, the other capacitor will still function, preventing the circuit from being electrically shorted. In addition, Tandem products only require one capacitor instead of two regular capacitors to provide redundancy from the perspective of functional safety,whichisalso effective in saving space on the board.